1) Version Register is mapped into M68000 space to access some informations :
$A10000 $A10001 Version register
=> Where is located physically this register? In Bus Arbiter Chip?
2) Always in M68000 space : an address can be used to reset Z80 :
$A11200 $A11201 Z80 reset
=> What chips is involved in this operation? What chip catch the address and set the signal to the Z80Reset pin?
Questions About Megadrive Chips/Signal
Moderator: BigEvilCorporation
-
- Very interested
- Posts: 2442
- Joined: Tue Dec 05, 2006 1:37 pm
- Location: Estonia, Rapla City
- Contact:
Re: Questions About Megadrive Chips/Signal
Z80 bus request and reset come from bus chip, using the single data line that is connected to it. Z80 banker also is done by that chip, one bit at a time.
Version register with its many bits comes from the IO chip, and !FDC (MCD presence) and region signals also connect to it.
IO chip has all data lines of both buses connected and is instrumental in bus crossings using !ZTOV and !VTOZ signals. !IO signal that is fed by bus chip activates it. Bus chip has most of the address lines connected and does the primary address decode, but it has only one data line connected so any registers it has are 1 bit wide. Remaining address lines connect to IO chip and together they pass all of the address lines between the two buses.
Version register with its many bits comes from the IO chip, and !FDC (MCD presence) and region signals also connect to it.
IO chip has all data lines of both buses connected and is instrumental in bus crossings using !ZTOV and !VTOZ signals. !IO signal that is fed by bus chip activates it. Bus chip has most of the address lines connected and does the primary address decode, but it has only one data line connected so any registers it has are 1 bit wide. Remaining address lines connect to IO chip and together they pass all of the address lines between the two buses.
Mida sa loed ? Nagunii aru ei saa
http://www.tmeeco.eu
Files of all broken links and images of mine are found here : http://www.tmeeco.eu/FileDen
http://www.tmeeco.eu
Files of all broken links and images of mine are found here : http://www.tmeeco.eu/FileDen
Re: Questions About Megadrive Chips/Signal
Very Clear !TmEE co.(TM) wrote: ↑Tue May 31, 2022 10:01 amZ80 bus request and reset come from bus chip, using the single data line that is connected to it. Z80 banker also is done by that chip, one bit at a time.
Version register with its many bits comes from the IO chip, and !FDC (MCD presence) and region signals also connect to it.
IO chip has all data lines of both buses connected and is instrumental in bus crossings using !ZTOV and !VTOZ signals. !IO signal that is fed by bus chip activates it. Bus chip has most of the address lines connected and does the primary address decode, but it has only one data line connected so any registers it has are 1 bit wide. Remaining address lines connect to IO chip and together they pass all of the address lines between the two buses.